Pompier

Revision as of 17:40, 23 December 2014 by Wrangler (talk | contribs) (Adding missing info from RS:VA I&E)
Pompier
Pompier
Production information
Manufacturer
Use Forest & Urban Firefighting
Class
Technical specifications
'Mech type Inner Sphere
Mass
Chassis
Armor
Engine
Communications System Irian UHF
Targeting Tracking System None
Heat Sinks 1
Speed km/h
Armament

1x FlexiSprayer
*1x Salvage Arm
Searchlight
Liquid Storage

BV (2.0) 106[1]


Description

The Pompier FireMech was constructed by GM's Kathil, for domestic firefighting needs. The ultra-light Industrial 'Mech was designed to transverse roads without damaging them. Since its introduction in 3044 the 'Mech has been purchased by various regions of the Inner Sphere and done well. It was designed to be able to go places that traditional firefighting vehicles are not able to. It is also designed to assist in urban environments where its special tools in fighting fires and salvage abilities are highly valuable.[2]

After the Jihad GM transferred production of the Pompier to plants on El Dorado and Talcott. Those lines focused on producing the Pompier HT model, which was in high demand to clean up the many chemical warfare sites that were created during the conflict.[3]

Weapons and Equipment

The Pompier is equipped with a Radial FlexiSprayer, which is principle equipment on the 'Mech to draw half-ton liquid Tank with either Water or fire-retardant foam. The 'Mech also can be use hose adapters and plugged into liquid tanker trucks or local fire hydrant. The 'Mech is powered by a Fuel Cell powered engine, but has low rate of speed.[2]

The 'Mech is protected by 1.5 tons of Industrial Grade Armor, so it can survive damage of fire. However, the 'Mech lacks Environmental Sealing to protect its pilot from smoke and chemical fires.[2]

The 'Mech has a Salvage Arm, which allows to be able to used in search and rescue and delicate firefighting situation where traditional equipment cannot go.[2]

Variants

  • Pompier GM-3HT 
    Pompier High-Threat is a emergency respond FireMech design to fight chemical fires. Introduced in 3060, the HT variant sacrifices it salvage arm for quadruple liquid tank storage capacity and environmental sealing enter high toxic fire situations. These 'Mech have seen in service with industrial complexes (space, air, and seaports) as well as traditional civil organizations. These organizations usually have a single or pair HT variants on standby.[2] BV(2.0)=106[4][5]

Notes

The Pompier has only appeared in the TRO: Vehicle Annex. No published record sheets exist as of yet for it or its variants found in the TRO.[2]

Additional GM design, 90 ton St. Florian FireMech is mentioned as well, but there are no known stats list anywhere for it.[2]

As of this time, the MUL Listings for the Pompier and its variants have listed details regarding battle values aside from intro dates listed.

References

  1. Record Sheets: Vehicle Annex, IndustrialMechs & Exoskeletons, p. 40 - Battle Value 2 Listed.
  2. 2.0 2.1 2.2 2.3 2.4 2.5 2.6 2.7 Technical Readout: Vehicle Annex, p. 220, "Pompier 'Mech Profile"
  3. Technical Readout: Vehicle Annex Revised, p. 198
  4. Record Sheets: Vehicle Annex, IndustrialMechs & Exoskeletons, p. 42 GM-3HT - Battle Value 2 and Stats.
  5. Master Unit Listing for Pompier GM-3HT FireMech - Introduction Date Only
  6. Record Sheets: Vehicle Annex, IndustrialMechs & Exoskeletons, p. 40 - GM-3CD Battle Value 2 and stat information.
  7. Master Unit Listing for Pompier GM-3CD FireMech - Introduction Date Only

Bibliography